DAB014 Multi-Angle Drill Guide for Cordless Drills

DAB014 Multi-Angle Drill Guide for Cordless Drills

The O'SKOOL DAB014 portable drill guide supports straight and angled drilling on flat workpieces and round stock. Set the angle on the guide-rod brackets, align the bit with your mark, and use the depth stop for repeated blind holes. The guide is used with a handheld drill; secure the workpiece and check the setup before drilling.

Features of the O'SKOOL Portable Multi-Angle Drill Guide

Compatibility with Flat and Cylindrical Workpieces

Use the flat base on flat stock or the V-grooves to position round stock beneath the bit. Select a drill bit suitable for the material and secure the workpiece so it cannot move or rotate.

Adjustable Angle Scale

Use the angle scale to set the guide rods for straight or angled holes. Loosen the handle and knob, adjust the rods, and check that both brackets show the same angle before tightening. The 0° setting is used for drilling perpendicular to the base.

Self-Centering Chuck

Suitable for handheld drills and compatible with flat or cylindrical workpieces. The 3/8" self-centering chuck, equipped with a 1/4" hex shank, can accommodate up to 10mm straight shank drill bits. This ensures that your drill bits are always perfectly centered, leading to more accurate drilling results.

Depth Stop Ring

For repeated blind holes, loosen the depth-stop screw, slide the ring to the required position, and tighten it by hand. Test the setup on scrap material and check the hole depth before drilling the workpiece.

Two V-groove

The two V-grooves help align round stock with the drilling center. They position the workpiece but do not replace securing it against rotation.

Center Guide Line

Use the center guide line to align the bit with the marked hole location. For centerline drilling, follow the guide-rod positioning steps in the user manual.

Large Handle

The removable handle provides a handhold for controlling the guide. Tighten the handle and angle-locking knob after adjusting the guide rods.

Anti-slipping Aluminum Base with Rubber Pad for Stability

The aluminum base has a rubber pad to improve contact with the workpiece and four mounting holes for an auxiliary base. Refer to the user manual for mounting-hole positions and suitable fasteners.

Before Drilling

1. Install the bit and tighten the chuck according to the user manual.
2. Set matching angles on both guide-rod brackets, then tighten the handle and knob.
3. Align the bit, secure the workpiece, and set the depth stop if needed.
4. Make a test hole and check its position, angle, and depth before continuing.

Drill Guide FAQs

Can this guide be used on round stock?

Yes. The base has V-grooves for positioning round stock. Secure the stock against rotation before drilling.

How do I repeat the same hole depth?

Set the depth-stop ring and tighten its screw. Check the result on scrap material before making repeated blind holes.

SKU: DAB014